Designed for peak performance
and reliability

The Silicon Carbide (SiC) Flame Tracker dramatically improves gas turbine performance while significantly reducing maintenance requirements. Available for a variety of gas turbines, the Flame Tracker flame sensor’s optical photodiode is designed for use with multiple fuels, low nitrogen oxide (NOx) combustors and steam injection. Reliable turbine operations using dry low NOx combustion require the sensitivity provided by the Flame Trackers.

Advantages


High sensitivity, fast response

Flame Tracker, with its SiC photodiode, has high sensitivity to the longer UV wavelengths that easily penetrate the fog of fuel and steam. This is advantageous over typical flame sensors that are sensitive to only the short UV wavelengths. In addition, the SiC sensor has an analog output with a very wide dynamic range and rapid response time. These features offer the ability to quickly—in less than 0.025 seconds—report flame status. This means interruption-free service and improved availability.

Reduced maintenance

The Flame Tracker flame sensor is equipped with quick disconnect connectors, allowing sensor replacement time to be reduced from hours to minutes. Its improved sensor-cooling feature lowers the impact of surrounding heat and extends the life of electronics.

Customized conversion kits

Customized flame sensor conversion kits are available for all turbine configurations. These sensor enhancements are mechanically and electrically interchangeable with existing systems. The kit solution simplifies upgrading older, maintenance-intensive systems to the superior performance of the Flame Tracker.

Multiple applications

Designed to replace outdated technology, the Flame Tracker is applicable to a variety of land-based and marine-based gas turbines, regardless of size. In addition, it is ETL, ATEX, and
IECEx certified.

Reliable, low-voltage operation

Providing a 4–20 mA industry-standard output signal, the Flame Tracker operates reliably with any fuel—with or without— steam injection. Unlike older flame sensors that require high voltage for operation, the Flame Tracker requires low voltage, which eliminates special wiring and explosion-proof conduit requirements.

 

Performance benefits


Provides reliable operation when using any fuel

Allows full operation during the water wash cycle

Reduces maintenance time

Operates on low voltage

Provides rapid response to flameout

Produces a wide dynamic range

Customized conversion kits

Meets all NFPA guidelines for flame detection on gas turbines

 

 

Specifications

Sensor responsivity and hydrocarbon flame
emission spectrum

 

Spectral response

Image
flame tracker spectral response

 

Material specification
Body mount

AISI 316 stainless steel

Housing

AISI 304 stainless steel (sealed and Argon filled)

Mechanical interface

3/4" NPT female

Electrical connector

MIL-C-38999 series III size 15 (5pin)

Sensor

Silicon Carbide (SiC) photodiode

flame tracker water cooled
RS-FS-9001, RS-FS-9004, RS-FS-9006


Flame Tracker

Operating parameters
Power requirements

24 VDC nominal, 12-30 VDC @ 100 mA

Output

4-20 mA (a module to convert output to other controller inputs is available)

Response time

< 0.025 seconds

Temperature range

-20ºF to +300ºF (-30ºC to +150ºC), 455ºF (235ºC) with specified water or air cooling

Process pressure

To 400 psig (2.8 MPa)

Sensitivity

5 mA @ 1x1010 photons/in2/sec. @ 310 nm


お気軽にお問い合わせください。

リクエストが送信されました。
関心をお寄せいただき、ありがとうございます。 担当者が折り返しご連絡を差し上げます。