Panametrics pool water application note
Success stories

Heat exchanger for a swimming pool

2 min read

Panametrics' Customer Story
Panametrics PT900 application note


A Facilities Management customer in Europe wanted to reduce the cost of operating its swimming pool. The client invested in a new electric (20kW, 3 phase) heat exchanger replacing an outdated natural gas fed heat exchanger which had become very expensive over the years. The heat pump supplier had set high expectations and so the client wanted to ensure the recommended water flow rate through the new heat exchanger could be achieved in order to optimize the pool’s efficiency. To do so the client turned to Panametrics.



Energy measurement:

• Medium water

• Water temperature intake: 16-20ºC (61-68°F)

• Water set temperature: 28°C (82.4°F)

• Pipe material: PVC

• Diameter: DN50 (2”)

• Wall thickness: 2mm

PT900 Panametrics application note
Panametrics' Solution

Knowing that the average temperature difference (outlet minus inlet) would be smaller with increased water pump capacity, the team expected the heat transfer to increase with higher pump capacity. Using a PT900 Clamp-on Flow Meter with the clamp on Pt1000 temperature probes confirmed this. The client lowered the maximum water capacity to meet the prescribed velocity limitations of the heat pump. With an electric power input to the heat pump of 4kW the customer was able to harvest almost 19.7kW, well within the supplier’s specifications.


Using the PT900 gives benefits:

• Reliable and accurate liquid flow measurements

• Fast and easy to install

• Sensor accessible without interruption of flow

• Ability to calculate energy with temperature probes



Panametrics’ PT900 Clamp-on Flow Meter confirmed the water flow rate and provided the customer with the peace of mind that the investment in an electric heat exchanger was worthwhile. Switching from gas to a heat pump to warm the pool cuts the customer’s energy bill by about 50%.

PT900 application note diagram

This demonstrates the Transport PT900 energy measurement capability that can be promoted for this type of assessments made by facility management companies for their utility customers. In this specific case we used CF-LP transducers and clamp on temperature probes.


PT900 panametrics application note

Learn more about Panametrics' Portables Flowmeters

Visit our Water and wastewater Industry Solutions page

Download Application Note here