Druck Knowledge Base | FAQ | Accessories
Find below Drucks knowledge base and FAQ for Accessories
If you'd like to contact Druck directly, please click here or email us at druckcontact@bakerhughes.com
For all other FAQ content click here.
The Blanking Plug for the Pressure Port is part number PVS116M1823-1
The Blanking Plug for the Pressure Module Port is part number IO620-BLANK
The IDT600-1 dirt trap could be used as this will prevent particles and droplets of liquid from entering the PACE controller through the Outlet port.
It will probably not stop humidity entering the controller, for this you could probably use a drier or in line desiccant.
Note:- Maximum pressure is 35 bar, needs to be mounted vertically.
See datasheet
All the seals for the valves IO620-PRV-H1 to IO620-PRV-H5 are contained in the PV623 / PV623G seal kit, part number IS620-18.
For replacing the pressure port on the IDT622/IDT621 you can use the part number IO-ADAPT-QF.
This part number include items 10 to 50 in the image below.
Ensure items 40 and 50 are fitted as shown below.
The fitting instructions are attached.
